Magazine Stand: Lumber required 20 ft. 1 in. x 12 in Get out ends first to dimensions given. Cut mortises for the tenons on the ends of the top and bottom shelves, the top of the lower ones 5 in. above the floor and the top of the upper ones 35 in. above the floor.

These shelves do not fit in rabbet. Next cut rabbets 1-4 in. deep for the other two shelve; the top of the lower one being 15 in. and the top of the upper one 25 in. above the floor. Cut holes for pins as described in directions for piano bench.

The brace (a), below the lower shelf has no tenons and no rabbet but just fits snug and is set back from the edge of the shelf about an inch, as shown by dotted lines in end view.

It is fastened by two screws from underneath as shown. These screws need not be plugged, as the holes will not show.

Make the tenons on the ends of the lower shelf about 2 in. wide and about 1 1-2 in. for the upper tenon, the tenons being full thickness of the shelves

.